ERR 4 — memory error (JOWA SEAGUARD): what to do?

Q: ERR 4 — memory error (JOWA SEAGUARD): what to do?

Cause: Memory card loose or faulty (corroded contacts). What to do: Check the card and restart; replace the card; if needed, reset by removing the battery for 24 h and set the time

ERR 4 — memory error

JOWA SEAGUARD, 15 ppm bilge alarm (ows monitor)

Possible cause

Memory card loose or faulty (corroded contacts)

What to do

Check the card and restart; replace the card; if needed, reset by removing the battery for 24 h and set the time

Manufacturer's manual, p. 22

See the assembly on the 3D model

Other JOWA SEAGUARD faults

ERR 2 — clock failureHardware failure ERR 8 — sensor not connectedBroken/loose cable or faulty sensor ERR 10 — sensor cleaning requiredNo clean water, dirty sensor, failed auto-flush, air bubbles, faulty sensor ERR 20 — sensor temperatureTemperature outside +1…+60 °C or faulty sensor ERR 40 — log truncatedLog recording interrupted by power failure ERR 80 — unknown errorSoftware failure or no ID in the Information menu PPM: O/R — out of rangeValue outside 0–30 ppm, sample too dirty, faulty sensor

From the manufacturer's manual “Manual JOWA SEAGUARD”. Check against the original on board before work.

This page was translated automatically from the manual summary. Part numbers, codes and page numbers are as in the original.