Fault 5.0 — High current
JOWA OIL-A TRIOSEP, bilge water separator (ows) with 15 ppm alarm
Possible cause
Pump motor overload
What to do
Manufacturer's manual, p. 16Reset via button on thermal relay Q01, then press red pushbutton-lamp on panel
See the assembly on the 3D model
Other JOWA OIL-A TRIOSEP faults
Fault 6.0 — Flow failureNo signal from flow relay while pump is runningFault 7.0 — High ppm15 ppm alarm indicates exceedancePump stopped, oil level faultOil level sensor in Tank 1 did not reset within 5–30 s
From the manufacturer's manual “triosepspecial ver 2”. Check against the original on board before work.
This page was translated automatically from the manual summary. Part numbers, codes and page numbers are as in the original.