9.1.1 Testing and correct operation of the mooring winch brakes
CoreChemicalLNGLPGOilAsked to: Master, Chief Officer, 2nd / 3rd Officer, RatingsWhere: Cargo Control Room, Documentation, Mooring Decks
Do the Master and deck officers know the company procedure for testing and using the mooring winch brakes, and are there records showing the brakes were tested at the required interval, after maintenance, and whenever they slipped early?
In one lineBrakes are tested yearly, after maintenance and after slippage, set to 60% of SDMBL, applied correctly, and lines are reeled in the correct direction.
How to answer
- Describe how the brake test is done with the test kit or jack, as per the company and maker's procedure: apply the brake at the set torque, apply the load and record the rendering point
- Explain that MEG4 sets the brake holding capacity at 60% of the ship design MBL, and how you check it
- Explain how the brake is applied correctly: the right number of turns, a torque wrench or marked handle, and the line reeled in the direction that gives full brake holding
- Explain when you retest: after liner replacement, after any maintenance on the brake, or if the brake slips early
- Explain that the drum is taken out of gear with the brake on when in service, and the locking pin is fitted
What the inspector looks for
- Brake test records for each winch: date, test load and result
- Tests done periodically (typically yearly), after maintenance on the brake and after any early slippage
- Brakes set to hold the required load, with a brake test kit available or a shore test arranged
- Brake linings and drums in good condition, with no oil or rust
- Correct reeling direction marked, and lines on the drum reeled correctly
Have ready to show
- Brake test records and certificates
- Brake test kit and its calibration
- PMS records for winch maintenance
- Brake holding capacity marking
- Mooring arrangement drawing
Avoid
- No test records, or tests overdue
- Brakes worn or contaminated
- Lines reeled in the wrong direction on the drum
- Crew unable to explain how the brake is set
← 8.99.11 Independent verification of cargo piping systems line up9.1.2 Was the vessel satisfactorily moored →
Practise in the interview trainer All questions
An independent guide written by seafarers for seafarers. It is not affiliated with or endorsed by OCIMF and does not reproduce the SIRE 2.0 Question Library: questions are put in our own words. The official library and guidance are published by OCIMF (ocimf.org). Always follow your company's SMS.