搜索说明书
ΔP alarmAlfa Laval Moatti L280, 故障, 第 14 页Insert clogged by dirt or sludge. Start troubleshooting at once; clean the insertSludge dosage valve does not startTeamTec Golar OG 200, 故障, 第 45 页Circulating pump off, chamber below 600 °C, relay, inverter or motor fault. Start the pump, check AL setting and temperature, relays d9/d10, inverter and motorSludge dosage valve stops after a whileTeamTec Golar OG 200, 故障, 第 45 页Chamber temperature falls (wet sludge) or motor overload (OL2 on inverter). Drain water from sludge, check the thermal overload settingNo flame from the sludge burnerTeamTec Golar OG 200, 故障, 第 46 页Steam/air solenoid, low atomising pressure, too much water or air, damaged sludge nozzle. Check solenoid s7 and pressure, drain the tank or use position 1, reduce air, clean the nozzleLow sludge / steam pressure alarmTeamTec Golar OG 200, 故障, 第 47 页Sludge below 0.5–1 bar or steam/air below 6–9 bar, closed valves, faulty switches. Adjust supply pressures, open valves, check switches b14 (0.2 bar) and b21 (2 bar)转鼓未达到额定转速或耗时过长Westfalia OSA 7, 故障, 第 58 页制动器未释放、电机接线错误、离合器摩擦片油腻或磨损、摩擦片数量不足、转鼓摩擦向心泵、上框架内有渣滓、蜗轮打滑. 释放制动器、检查接线、干燥或更换离合器摩擦片、增加摩擦片、重置转鼓高度、清洁框架、拧紧蜗轮夹紧螺钉TeamTec Golar OG 200船用焚烧炉（油泥、污水污泥和固体垃圾）, 第 46 页 … SLUDGE BURNER 3
(Sludge dosage valve
running)
Faulty sludge dosage valve:
Check dosage valve.
(Stator and rotor).
Sludge … TeamTec Golar OG 200船用焚烧炉（油泥、污水污泥和固体垃圾）, 第 45 页 … 10
SLUDGE DOSAGE Sludge circulating pump is | Check pump.
VALVE DOES NOT not running.
START
(Selector switch "Sludge … TeamTec Golar OG 200船用焚烧炉（油泥、污水污泥和固体垃圾）, 第 35 页 … SLUDGE BURNER AUTO
Prior to buming of sludge, heat up the sludge and drain off water from sludge … Hamworthy Super Trident ST6A生化污水处理装置，IMO MEPC.2(VI), 第 52 页 … In this way the small
quantity of sewage sludge will be mixed with waste oil and incinerated without … Hamworthy Super Trident ST6A生化污水处理装置，IMO MEPC.2(VI), 第 53 页 … Incinerator sludge tank
H.
Engine room sludge transfer pump
J.
Engine room sludge tank
K.
Alternative desludging. Metered … Westfalia OSA 7自清式离心分油机（滑油分油机）, 第 33 页 … De-sludge the bowl: see 2.3.3.1, No. 3.
Flush bowl with oil and de-sludge … Westfalia OSC 4自清式离心分油机, 第 50 页 … De-sludge the bowl: see 2.3.3.1, No. 3.
Flush bowl with oil and de-sludge … Westfalia OSA 7自清式离心分油机（滑油分油机）, 第 32 页 … To avoid impaired separating efficiency,
the separating time should, however, not be extended until the sludge
space is … Westfalia VESC-1分油机控制单元, 第 16 页 … LSL sludge tank level switch
In the case of optional Centripack modules with sludge tank, the sludge pump … Westfalia VESC-1分油机控制单元, 第 1 页 … sludge tank level switches; outputs drive the feed, displacement/filling water and operating water valves, the sludge pump …