SeaVint

JOWA REP-1L

Ultraljubičasti sterilizator pitke vode

JOWA REP-1L sterilises drinking water with one low-pressure UV lamp in a stainless steel chamber. A photocell measures UV intensity and gives an alarm and closes the outlet solenoid valve when it falls below 30 %; a lamp ammeter monitors the lamp. It is fitted after the pH filter, storage tank and hydrophore, as close to the tapping point as possible. The manual covers specification, installation, start-up, chamber cleaning, lamp and quartz jacket replacement, a troubleshooting chart, wiring and parts.

Postupci održavanja

Replacing a quartz jacket

  1. Switch off the operating switch and the automatic fuse; drain the chamber. str. 14
  2. Remove the wing nuts and end covers, disconnect the lamp and pull it out. str. 14
  3. Remove the O-ring flange (three 6 mm socket screws), slide the quartz out on a 10–18 mm wooden or plastic rod. str. 14
  4. Fit new O-rings (soap inside), wipe the quartz with alcohol and do not touch it with bare hands. str. 14
  5. Slide the new quartz in on the rod, refit flanges hand-tight to bottom, pressurise and check for leaks; refit lamp and covers. str. 14

Kvarovi i što učiniti

Tehničke specifikacije

UV lamp1 low-pressure lamp, 158 cm, 65 W (27 W at 253.7 nm)str. 3
UV dose> 35 000 µWs/cm² at 2.7 m³/h, 60 % transmissionstr. 3
Capacity2.7–5.4 m³/h depending on water qualitystr. 3
Intensity alarmbelow 30 %str. 3
Power150 W, 230 V 50/60 Hzstr. 3
Working pressureup to 10 barstr. 3
ChamberSS 316, 1630 × 104 × 275 mm, 16 kgstr. 3
Lamp voltage (unlit)about 600 V for 152 cm lampstr. 16

Izvor: priručnik proizvođača „EM-26 RE-UV-PURIFIERS”, 21 str. Brojevi stranica odnose se na izvornik. Prije rada provjerite priručnik na brodu.

Stranica je automatski prevedena. Brojevi dijelova, kôdovi i stranice su kao u izvorniku.