SeaVint

Zhenjiang FH75

Free-fall lifeboat launching appliance

Stern launching arrangement for a BH-F7.8 type totally enclosed free-fall lifeboat: a welded ramp with rollers, a hydraulic A-frame davit with boat winch for launching and recovery by falls, the release hook unit, the fitted (gripping chain) unit and the forward lashing with hydrostatic release. The boat can be launched by free fall at up to 10° trim and 20° list, by falls, or floats free if the ship sinks. The manual gives the technical data, construction, weekly checks, wire renewal rules and step-by-step launching and recovery.

Нажмите на деталь на модели — увидите номер и назначение.Открыть 3D-мануал

Обучающие видео

Процедуры обслуживания

Launching by free fall

  1. Confirm the boat's slingers are not connected to the fall chain hooks; leave the fitted unit, it does not affect a free-fall launch. стр. 15
  2. Crew board and fasten the seat belts. стр. 15
  3. Secure loose objects and close all openings. стр. 15
  4. Start the boat engine. стр. 16
  5. Open the release hook with the release mechanism inside the boat. стр. 16
  6. The boat slides down the ramp into the water and leaves the ship. стр. 16

Launching by falls

  1. Start the pump motor. стр. 16
  2. Hang the slingers on both sides of the boat on the hooks of the boat fall chains. стр. 16
  3. Open the slip hook of the fitted unit so the fitted plate turns up clear of the hook. стр. 16
  4. Crew board. стр. 16
  5. Open the release hook from inside the boat. стр. 16
  6. Open the change valve of the cylinders: the davit arms move fully outboard. стр. 16
  7. Open the change valve of the winch and lower the boat to the sea. стр. 16
  8. Unhook the slingers and stow them in the slinger box; start the engine and leave the ship. стр. 16

Float-free release

  1. When the ship sinks, water pressure separates the forward lashing and the fitted unit. стр. 16
  2. The boat floats up and the release hook separates automatically. стр. 16
  3. The crew board the floating boat, start the engine and leave the ship. стр. 16

Recovering the boat

  1. Swing the arms out and hang the slingers on the fall chain hooks. стр. 16
  2. Open the slip hook of the fitted unit. стр. 17
  3. Hoist with the winch change valve; the limit switch stops the winch at the set position. стр. 17
    A free-fall boat can be recovered only with the hydraulic drive
  4. Turn the arms inboard with the cylinder change valve; the boat enters the ramp. стр. 17
  5. Hang on the long link of the forward lashing, then the release hook. стр. 17
  6. When the arms are home, stop the cylinder; take the slingers off the fall hooks and stow them. стр. 17
  7. Close the slip hook of the fitted unit so the boat is held firmly. стр. 17

Интервалы технического обслуживания

ЧтоКогдаЧто делатьМануал
Davit and boat winchweeklyOperate and check by the appointed personстр. 15
Release hook, fitted unit, pivot unit, hydrostatic releaseweeklyCheck; make sure the boat can be secured and released quicklyстр. 15
Rollers, release hook, pivot unit, sheavesoftenFill with greaseстр. 15
Davit fallsnot more than 2 monthsTurn end for endстр. 15
Davit fallswhen 10 % worn, diameter shrunk, twisted or deformedRenewстр. 15

Технические характеристики

Max. working load75 kNстр. 14
Max. hoisting load56 kNстр. 14
Rope hoisting speed> 3 m/minстр. 14
Davit weightabout 9000 kgстр. 14
Free-fall launch possible attrim up to 10°, list up to 20°стр. 14
Launch by falls possible attrim up to 2°, list up to 5°стр. 14
Hydraulic working pressure15 MPaстр. 22
Relief valve setting17 MPaстр. 22
Hydraulic oilN46 (ISO VG46)стр. 4
Wire rope18 × 19 non-rotating, galvanisedстр. 4
Applicable boatBH-F7.8 free-fall lifeboat or similarстр. 4
RulesSOLAS MSC.47(66), LSA Code MSC.48(66), tests per IMO A.689(17)стр. 14

Запчасти и номера по каталогу

ДетальНомерКол.Мануал
Arm support bolt M24×60 (GB5783) with nut M24 and washer 24GB5783 M24×604стр. 24
Arm support rubber pad215ZF507-04-21стр. 24
Arm support square steel □250×250×91стр. 24
Arm support plate215ZF507-04-32стр. 24
Fitted unit gripping block215ZF510-10-2-0стр. 28
Fitted unit gripping chain215ZF510-10-1-0стр. 28
Fitted unit bolt M16×70 (GB5783) with nutM16×70стр. 28
Release hook unit215ZF506-14-01стр. 2
Boat fall unit215ZF506-06-01стр. 2
Fitted boat unit215ZF510-06-01стр. 2
Limit unit215ZF510-12-01стр. 2
Aft lashing215ZF506-12-01стр. 3
Pipe system215ZF507-02-01стр. 2

Источник: мануал производителя «FH75 free-fall lifeboat launching appliance», 33 стр. Номера страниц указаны по оригиналу. Перед работой сверяйтесь с мануалом на судне.

Страница переведена автоматически. Номера деталей, коды и страницы — как в оригинале.