Draught failure alarm (TeamTec Golar OG 200): apa yang harus dilakukan?

Penyebab: Low furnace negative pressure, damper in manual, controller settings, blown fuse, faulty controller or damper motor. Tindakan: Set damper to Auto, check controller values and fuses, replace controller or damper motor

Draught failure alarm

TeamTec Golar OG 200, shipboard incinerator (sludge oil, sewage sludge and solid waste)

Kemungkinan penyebab

Low furnace negative pressure, damper in manual, controller settings, blown fuse, faulty controller or damper motor

Yang harus dilakukan

Set damper to Auto, check controller values and fuses, replace controller or damper motor

Manual produsen, hlm. 46

Lihat rakitan pada model 3D

Gangguan TeamTec Golar OG 200 lainnya

Flame failure alarm at startNo ignition spark, diesel solenoids not opening, dirty nozzle, too much primary air, dirty photo resistor, poor oil Flame failure when stage 2 startsToo much primary air, damper opening too early Low diesel oil pressure alarmNo oil supply, faulty pressure switch b13, pump problem Flue gas temperature high alarmAbove set value (normal 400 °C), faulty controller u1 or thermocouple Combustion chamber temperature high alarmAbove 1200 °C, faulty controller u2 or thermocouple Sludge dosage valve does not startCirculating pump off, chamber below 600 °C, relay, inverter or motor fault Sludge dosage valve stops after a whileChamber temperature falls (wet sludge) or motor overload (OL2 on inverter)No flame from the sludge burnerSteam/air solenoid, low atomising pressure, too much water or air, damaged sludge nozzle Low sludge / steam pressure alarmSludge below 0.5–1 bar or steam/air below 6–9 bar, closed valves, faulty switches Flue gas fan does not startTripped breaker e11, contactor, motor or switch

Dari manual produsen “EM-10 INCINERATOR”. Periksa dokumen asli di kapal sebelum bekerja.

Halaman ini diterjemahkan otomatis. Nomor suku cadang, kode, dan halaman sesuai aslinya.